A foolish project I conceived to create fireballs from a custom 3D printed whoofler that plugs directly onto a can of butane lighter refill gas. The liquid is just well diluted dishwashing liquid.
If you ever consider making one of these (which I would obviously advise against) note that it does pose a fire risk in some areas, wind can blow the fireball into your face and it emits enough sooty smoke to make a mess and set off smoke detectors.
To avoid MORE technical stupidity like this, I recommend AGAINST subscribing to my channel in case you are led astray into the dark side of technology. And do NOT like this video just because it is dangerous and pleases you.
#shorts
The openscad script below is for a foamy whoofler. Note that foamy whooflers may cause minor infernos and shouldn't actually be whoofled.
//MR WHOOFLER FIRE FOAM MAKER
//DO NOT EVER MAKE ONE OF THESE
$fn=100;
difference(){
union(){
difference(){
union(){
//first additions
//finger rim
translate([0,0,0])
cylinder(h=3,d1=45,d2=45);
//base
translate([0,0,3])
cylinder(h=20,d1=30,d2=15);
//upper cone
translate([0,0,23])
cylinder(h=40,d1=15,d2=50);
//upper rim
translate([0,0,63])
cylinder(h=10,d1=50,d2=50);
}
//first subtractions
//inner foam cone
translate([0,0,25])
cylinder(h=38,d1=15,d2=48);
//inner base
translate([0,0,-1])
cylinder(h=23,d1=30,d2=12);
//upper rim
translate([0,0,63])
cylinder(h=11,d1=48,d2=48);
}
//second additions
//injector base
translate([0,0,0])
cylinder(h=23,d1=12,d2=12);
//diffuser cone
translate([0,0,25])
cylinder(h=10,d1=15,d2=0);
}
//second subtractions
//twelve radial vents
translate([0,0,25])
for (i=[0:30:330])rotate([65, 0, i]){
cylinder(h=8, d1=1, d2=1);
}
//diffuser cone inner
translate([0,0,24])
cylinder(h=10,d1=14,d2=0);
//4mm injector entrance
translate([0,0,-1])
cylinder(h=4,d1=4,d2=4);
//tapered transition
translate([0,0,3])
cylinder(h=5,d1=4,d2=3);
//seal taper
translate([0,0,8])
cylinder(h=5,d1=3,d2=2.8);
//tapered transition
translate([0,0,13])
cylinder(h=1,d1=2.8,d2=1);
//gas feed pipe
translate([0,0,12])
cylinder(h=15,d1=1,d2=1);
//x-ray box
//translate([-30,-30,-1])
//cube([60,30,100]);
}